Die plates for
seal presses

Engrave your own custom die plates for seal presses

Add an individual touch to your letters and invitation cards with a stylish embossing. We show you how to engrave your own die plates for seal presses with your Trotec laser.

In case you are interested in more information on seal presses visit the Trodat website.

準備

Required material

Standard Delrin sheets for engraving and cutting out the embossing plates, a seal press, high-quality paper

Used Trotec Laser

Speedy300
60 watts
1.5 inch lens

Seal Press Plates

ZIP

今すぐダウンロード

ZIP

今すぐダウンロード

Seal Press Template

PDF

今すぐダウンロード

PDF

今すぐダウンロード

ステップ・バイ・ステップ

ステップ 1

Step 1: Cut and engrave the embossing plates

Create your own design for the die plates or use the one we've prepared for you. Then send it to the laser with the parameters below for cutting and engraving. The laser parameters may vary, as they depend on the machine used and the available laser power.

RECOMMENDED PARAMETERS:

Engraving: Black: power 60%, speed 20%, 500 ppi, Air Assist on

Cutting: Red: power 50%, speed 1,0%, frequency 1000 Hz, Air Assist on

ステップ 2

Step 2: Glue the plate to the seal press

Take the newly made die plate out of the laser and clean it thoroughly. Simply wash the finished Delrin die plates with water and a little soap or dish liquid and wipe off any still adhering dust with a brush. After gluing the plate to your seal press you can start embossing fine papers.

ステップ 3

Alternative: Engrave a text plate for a rubber stamp

You can also use the embossing plate design for engraving a text plate for a rubber stamp. We've made a separate CorelDraw file for this. Make sure to adjust your laser to the parameters below when engraving the rubber text plate.

RECOMMENDED PARAMETERS:

Engraving: Black: power 100%, speed 12%, 600 ppi, Air Assist on

Cutting: Red: power 80%, speed 0,7%, frequency 1000 Hz, Air Assist on

Speedyシリーズ
名入れに最適なレーザー加工機です。

レーザー加工機のご紹介

レーザーの用途や設定に関するご質問はありますか？
喜んでアドバイス致します

お問い合わせ