Create your own design or use our template. If you work with transparent TroGlass, please note that the contours shine through the transparent material. Now select the desired motifs from the template according to your ideas. Then send the job to the laser with the settings below.

Print settings:

Now make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power. To process the plywood, use the aluminum cutting grid table and the nozzle with the small hole diameter. Cover the rest of the work surface around the material to create a vacuum and provide efficient removal of dust and fumes. Then start the engraving and cutting process.

Laser Parameters:

After the laser process, remove all cut parts from the laser. If necessary, carefully clean the cut edges with a damp cloth.

• Glue a wooden motif with double-sided adhesive tape edge to edge on one side of the TroGlass element.
• Afterwards still the tail is stuck on suitably.
• Turn the Easter decoration upside down and stick a wood motif on the back. With transparent TroGlass, make sure that the contours shine through.
• Also on the second side the tail is now attached with double-sided adhesive tape. The decoration can be used from both sides!
• The cut-out wooden bunnies can be used as sprinkling decoration. Glue a little tail on one side of these as well.
• Arrange the bunnies into a cheerful and colorful Easter decoration!