Start by either creating your own design or using our template. We scanned our agate disk to adapt our design directly to the shape of the stone. Send the job to the laser using the settings below.

Print settings

TIP:

To achieve a perfect result  for our detailed graphics we used the highest possible resolution of 1000 dpi when laser engraving.

Position the agate disk onto your laser machine bed and focus on the surface. If the stone is rounded, focus on the average value of the engraving area. Next you should create the material parameter settings. These parameters can vary depending on your laser machine and its available laser power.

Laser Parameters engraving

Tip:

Due to the +1.5 mm z-offset (out of focus) the contrast created is higher than when engraving in focus.

There is no post processing required for the agate, simply add your leather strap and your pendant is ready to wear!