--------------------------
  1. Trotec Laser
  2. Ressourcer
  3. Laserprojekter
  4. Lasercut and engraved Cardboard Chair
cardboard furniture laser cutting

Lasercut and engraved
Cardboard Chair

Step by step guide

Forberedelse

Required material
  • 2 pieces of
    2mm corrugated cardboard
Trotec laser used
  • Speedy 300
  • 30 watts
  • 1.5 inch lens
Cardboard Chair

ZIP

Download nu
csm_Paper-chair_29c1399615.png

PDF

Download nu

Trin for trin

chair laser cut from cardboard
Trin 1

Step 1: Preparation

Use the vacuum table with the honeycomb tabletop for cutting and engraving the cardboard.

chair made from cardboard laser
Trin 2

Step 2: Development

Print the first page of the PDF document (the engraving layout) in size of 610 x 300mm. Adjust the marker to the job and engrave it.
After the engraving part you have to turn around the cardboard horizontally and cut the cardboard (cutting file on the second page of the PDF document).
Then place the second cardboard sheet for cutting of the cross-brace elements in the laser. These are on the third page of the PDF document.

cardboard furniture laser cutting
Trin 3

Step 3: Used Laser Settings

Import the PDF file into Corel Draw, customize it as you want to or take your own design and send it to the laser.

Laser Settings

Front of the first cardboard
Engraving: Power: 40% - Speed: 100% - Frequency: 500 ppi - Air Assist: OFF - Z-Offset: 6mm
 
Back of the first cardboard
Cutting-in: Power: 7% - Speed: 3% - Frequency: 1000 Hz - Air Assist: OFF - Z-Offset: 6mm
Cutting: Power: 10% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON
 
Second cardboard
Cutting: Power: 20% - Speed: 1% - Frequency: 1000 Hz - Air Assist: ON

cardboard chair laser cutting
Trin 4

Step 4: Assembly

For the assembly have a look at the installation instructions.

cardboard chair laser cut
Trin 5

Step 5: Use

Now you can use your cardboard chair for everything you want.
Make it in another scale - then you can sit on it yourself because it is so stable.
Visit kurtl.com and have a look at a range of creative furniture out of cardboard.

Trin 6

Tips:

Use the vacuum table with the honeycumb tabletop for cutting and engraving the cardboard. You have to engrave the front of the cardboard and cut it on the back. That's why you have to turn it around after engraving and cut it on the other side.

Speedy-serien
 Den ideelle lasergraver og -skærer til personlig tilpasning.

Oplev lasergraverere- og -skærere

Har du spørgsmål til anvendelser eller indstillinger?
Vi rådgiver dig gerne fra A for Air assist til Z for z-forskydning.

Kontakt os
Stolt medlem af troGROUP Logo