Covid-19 Signs
Here you will find templates for the quick creation of Covid-19 signs from TroLase, TroLase Foil and TroGlass.
Covid-19 Signs
Here you will find templates for the quick creation of Covid-19 signs from TroLase, TroLase Foil and TroGlass.
Preparation
Required material
Sign "Wash your hands" Variant 1
- 1/4 sheet TroLase black/yellow 1.6 mm L704-206
- 1/4 sheet TroLase blue/white 1.6 mm L512-206 with double-sided adhesive foil on the back
Required material
Sign "Wash your hands" Variant 2
- 1/4 sheet TroGlass reverse glossy/white
- 1/4 sheet TroLase blue/white 1.6 mm with double-sided adhesive foil on the back
- Acrylic paint in black
Required material
Sticker "Keep distance"
- 1/4 sheet TroLase Foil red/white 0.2 mm
Machine used:
- Speedy 300
- 80 watts
- 1.5" lens
- Aluminum cutting grid table or honeycomb cutting tabletop
This sample can be produced with any other machine of the Speedy laser engravers.
Tip:
When working with TroLase or TroLase Foil, the following applies: If you use the entire work surface, use a vacuum table or an adhesive mat so that the material lies flat over the entire surface. Otherwise, cover the work surface with paper to create an optimal vacuum.
Step by step
Step 1: Import/Create Print & Laser Template
Feel free to make use of your own design or use our provided template. Next you'll be uploading the job to the laser with the settings below.
Important: If you use TroGlass Reverse, the file must be mirrored.
Print settings
Process mode | Resolution | Cut line |
---|---|---|
standard | 500dpi | none |
Halftone | Other |
---|---|
- | Optimized geometries, inner geometries first |
Step 2: Laser process
Next you'll need to choose you parameter settings. Keep in mind that our suggested parameters could be differrent, depending on the laser machine used and the available laser power.
Remove the protective foil from the TroLase Foil or TroLase surface and then place the material in your laser. If you use TroGlass Reverse it is recommended to remove the foil after the laser process.
Step 3: Assembly
For the assembly, start by removing the protective film on the back of the blue TroLase shield. Now stick the TroLase label onto the yellow TroLase or the white TroGlass Reverse label according to the markings.
The signs are now ready for use!
You can of course produce these signs in all possible colour and material combinations.