Covid-19 Signs
Use TroLase, TroLase Foil, and TroGlass to quickly create Covid-19 signs with these templates.
Preparation
Required material
Sign "Wash your hands" Variant 1
- 1/4 sheet TroLase black/yellow 1.6 mm L704-206
- 1/4 sheet TroLase blue/white 1.6 mm L512-206 with double-sided adhesive foil on the back
Required material
Sign "Wash your hands" Variant 2
- 1/4 sheet TroGlass reverse glossy/white
- 1/4 sheet TroLase blue/white 1.6 mm with double-sided adhesive foil on the back
- Acrylic paint in black
Required material
Sticker "Keep distance"
- 1/4 sheet TroLase Foil red/white 0.2 mm
Machine used:
- Speedy 300
- 80 watts
- 1.5" lens
- Aluminum cutting grid table or honeycomb cutting tabletop
This sample can be produced with any other machine of the Speedy laser engravers.
Tip:
When working with TroLase or TroLase Foil, keep the following in mind: The vacuum table works best if you're using the entire work surface, keeping the material flat over the entire surface. Otherwise, you can cover the work surface with paper to create an optimal vacuum.
Step by step
Step 1: Import/Create Print & Laser Template
Use the template we provided or create a design of your own. Then use the settings below to send the job to the laser.
Important: If you use TroGlass Reverse, the file must be mirrored.
Print settings
Process mode | Resolution | Cut line |
---|---|---|
standard | 500dpi | none |
Halftone | Other |
---|---|
- | Optimized geometries, inner geometries first |
Step 2: Laser process
The laser parameters may vary based upon the laser system and laser power available.
Remove the protective material from the TroLase Foil or TroLase surface and place the material in your laser. If you use TroGlass Reverse, wait until after the laser process to remove the protective material.
Laser Parameters:
Material | Color | Process | Power (%) | Speed (%) | ppi/Hz | Passes | Air Assist | Z-Offset | Direction | Advanced |
---|---|---|---|---|---|---|---|---|---|---|
TroLase Foil | black | Engrave CO2 | 55 | 80 | 500 | 1 | off | 1.5 | bottom to top | - |
red | Cut CO2 | 40 | 1 | 2000 | 1 | on | 0 | - | - | |
TroLase | black | Engrave CO2 | 65 | 80 | 600 | 1 | off | 1.5 | bottom to top | - |
red | Cut CO2 | 60 | 1 | 2000 | 1 | on | 0 | - | - | |
TroGlass Reverse | black | Engrave CO2 | 18 | 20 | 500 | 1 | on | 0 | bottom to top | - |
red | Cut CO2 | 60 | 1 | 2000 | 1 | on | 0 | - | - |
Step 3: Assembly
Before you attach the pieces together, take the the blue TroLase shield and remove the protective film on the back of it. Next, follow the markings to stick the TroLase label onto the yellow TroLase or the white TroGlass Reverse label.
Now the signs are good to go!
There is a wide range of color combinations to use. Feel free to get creative!