3D Wall Decoration: Elephant

Create your own design or use our template. Send the job to the laser with the settings below.

Print settings:

Now make the parameter settings. Our suggested parameters may vary depending on the laser machine used and the available laser power.

Place a TroCraft Eco plate in the laser device. Cover the remaining work area around the material to create vacuum. Then start the engraving and cutting process.

Laser Parameters:

After the laser process, remove the individual parts from the laser unit. The parts are arranged in size or sequence from bottom right to top left.

Take the part of the elephant head without ear cut-outs and insert it at the cut-outs into the two grid elements, in each case into the rearmost slot. Proceed in sequence with all other parts of the elephant head in the same way. The order depends on the size of the individual parts - the smallest element is placed in the front slot.

Finally, turn the elephant head over and push the rectangular plate through the two slots on the back. This fixes the elements and at the same time serves as a suspension eyelet.