Laser engraved
wedding glass

To mount the rotary attachment and plug it in, the laser has to be switched off. After that you can switch on the laser and put the prepared glass into the rotary attachment.

To prepare the glass you will need a paper towel, some water and a sponge or a spray. To prevent the glass from splintering, apply a moist paper towel to the surface. The easiest way to do this, is by using a sponge or a spray. Make sure that there are no air bubbles or wrinkles in order to get a perfect result.

Put your prepared glass into the rotary attachment and make sure that it is firmly attached. If your glass is conical, adjust the inclination angle until the surface you want to engrave is positioned parallel to the worktable.