Lasermade Jewelry
Necklace with Laser-Cut Pendant

This pendant is made of 13 laser-cut and engraved pieces. The exact correction of the cutting gaps guarantees a firm hold without glue and the engraving elements allow countless designs.

Preparation

Required material

TroLase Reverse gloss/gold 1/16"
Waxed cord or a ribbon

Trotec laser used

Speedy 360
60 watts
1.5 inch lens

Tips

Use a honeycomb cutting table or an acrylic cutting grid table to avoid back reflections

Pendant

ZIP

Download now

ZIP

Download now

csm_pendant_7688f3d5c1.png

PDF

Download now

PDF

Download now

Step by step

Step 1

Step 1: Design

Open the PDF template and send the design to the laser or create your own design and add a personal touch to the pendant.

Do you want to use a different material?

Note that the cutting gap has been optimized for TroLase Reverse 1/16". When using other materials it may be necessary to adapt parameters and geometries.

Step 2

Step 2: Laser Parameters

We used a Speedy 360 (60 watts power) to cut and engrave the material. We've sent the graphics with 600 dpi to the laser and used the following parameters:

Laser Settings

Engraving: Power: 100% - Speed: 60% - Frequency: 1000 ppi - Air Assist: On -
Z-Offset: 2.5mm
Cutting: Power: 50% - Speed: 0.6% - Frequency: 2000 Hz - Air Asisst: On

Additionally, we activated the optimized geometries function to achieve even higher quality.

Step 3

Step 3: Cleaning and assembling

It may be necessary to clean the pieces and remove dust with a soft cloth. After that you can easily put the pieces together. There is no glue needed, because the pieces fit together perfectly.

Tip:

To cut out the stand, you can also use our template.

Step 4

Step 4: Attach the ribbon

To assemble the piece of jewelry, take the small disk with the hole, pull the ribbon through and fix it with a knot. Cut the excess from the ends with scissors.

In the pictures below we have omitted the ribbon, so you can see the assembly better.