3D bullet labyrinth made of TroLase ADA Signage

Design your box or use our template. Send the file to the laser using the following print settings:

Process mode	Resolution	Cut line
Cut Job	1000 dpi	none

Halftone	Others
color	enhanced geometries, inner geometries first

Tip:

We created a file on makeabox.io for the base frame of the labyrinth and adapted the file for ADA material. For TroLase ADA Signage enter a value of 0,2 mm into the field entitled "kerf."

Place the acrylic cutting grid into your laser and cut the outer walls and the bottom out of the black TroLase ADA Signage. For the playing field, we used the white ADA Signage with the same parameters. We scratched the positions of the individual "labyrinth inner walls" on the playing field so that we could assemble them correctly.

The parameters required may vary depending on the laser power and the machine used.

Laser Parameters

Color	Process	Power (%)	Speed (%)	ppi/Hz
Scratching: red	cut CO2	10	1.5	1000
Marking letters: blue	cut CO2	25	1.5	1000
"Wide" scratching: cyan	cut CO2	20	1.5	1000
Cutting: green	cut CO2	95	0.8	1000

Passes	Air Assist	Z-Offset	Advanced
1	on	1 mm	-
1	on	2 mm	-
1	on	4 mm	-
1	on	-1.6 mm	-

Tip:

For a clean end result, leave the protective foil on the material during laser processing. But don't forget that you will have to remove the foil from every single piece!

Remove the protective foil and clean the surface with multi-purpose cleaner and a soft cloth. Then stick the bottom and one long side part together. Insert the playing field into the holding slots and add one of the short side parts. Close the construction with the two missing side parts. Finally, position the single "walls" of the labyrinth into the marked areas. Now your unique 3D bullet labyrinth is ready.

Tip:

Clean the edges with an alcohol-based cleaner or solution to prevent them from losing their color.