Inspection stickers out of TroLase Foil

Preparation

Required material

1 sheet TroLase Foil green
Material to cover the engraving table (e.g. paper)

Machine used

Speedy 360, 70 watts
1.5" lens
vacuum table with honeycomb cutting table

For this sample you can use any laser machine from the Speedy laser engraver series.

Tip

TroLase Foil metallic can be processed with a fiber laser as well. (For more information, see DIY Trophy Label.)

trotec-inspection-stickers.zip

ZIP

Download now

ZIP

Download now

Step by step

Step 1

Step 1: Import design

Make your own design or import our template. Adapt it to your requirements. Send the job to the laser using the driver settings below.

Print settings:

Process mode	Resolution	Cut line
Standard	600 dpi	none

Halftone	Others
Color	Optimized geometries, inner geometries first

Step 2

Step 2: Engraving TroLase Foil

Put TroLase Foil into your Trotec laser and cover the rest of the engraving table to maximize the vacuum effect. Start the engraving from the bottom to prevent the dust from settling on the engraved areas. The parameters can differ depending on the laser machine used and laser power available.

Laser parameters

Process	Color	Process	Power (%)	Speed (%)
engraving	black	Engrave CO₂	60	80
scratching	red	Cut CO₂	10	1.5
cutting	blue	Cut CO₂	40	2

ppi/Hz	Passes	Air Assist	Z-Offset	Advanced
600	1	on	+0.5 mm	High Quality
1000	1	on	-	-
1000	1	on	-	-

Info:

During kiss-cutting you cut through only the top layer of the sticker material, while the backing layer remains intact. This allows the stickers to be easily peeled and removed from the backing layer.