You can import our template or create your own design. The file provided is suitable for a 14" laptop, but you can easily adapt it to any other device size.
The design consists of two parts: an outer component (with the pattern) and an inner component with a contour and marking for the seam.

Using the following printer driver settings, send the job to your laser:

Standard	500 dpi	none
Process mode	Resolution	Cut line

Colour	Optimized geometries, inner geometries first
Halftone	Others

Position the fabric (interior facing downwards) on the laser bed. Begin with the first graphic. Of course, you can personalise and individualize the bag before this step. Once you cut out the laptop cover, turn it over and, if required, use the laser to mark the seam line. It is strongly advised that you test your fabric prior to processing the entire piece.

You may need to adjust the laser parameters depending on the your specific laser machine and the laser power available. 

NOTE: The parameters for black softshell fabric are only necessary if you also want to engrave the material.

Laser Parameters (Optional):

Colour	Process	Power (%)	Speed (%)	ppi/Hz
Black	Engrave CO2	80	30	500

Passes	Air Assist	Z-Offset	Advanced
1	on	-	-

 Laser Parameters (Cutting):

Colour	Process	Power (%)	Speed (%)	ppi/Hz
Red	Cut CO2	10	1.5	1000
Blue	Cut CO2	7	2	1000

Colour	Passes	Air Assist	Z-Offset	Advanced
Red	1	on	-	-
Blue	1	on	+3mm	-

Insert the eyelet before you close the lateral seam. Please follow the instructions provided with your eyelet set. Next, close the seam on the left and the right sides of the cover. The scratching lines help you to use the correct position for the seam. Finally insert the fabric elastic band and knot it together.

Now, your laptop bag is ready!