Begin by importing the design file. You can create your own or use our ready made one. Our file is suitable for a 14" laptop, but you can easily adapt it to any other size.
The design consists of two parts: The outer part with pattern; and the inner part with outside contour and marking for the seam.

Send the job to the laser using the below printer driver settings:

Print Settings:

Standard	500 dpi	none
Process mode	Resolution	Cut line

Colour	Optimised geometries, inner geometries first
Halftone	Others

Please test the material before you start laser engraving the bag.

Position the fabric into the laser with the inside down and start with the first graphic. You can personalise the bag prior to this stage. Once you have cut out the laptop cover, turn the material and use the laser to mark the seam line (if required)

Adjust the parameter settings, which will differ depending on your laser machine and the available laser power. Please note: the parameters for black are only necessary for laser engraving the material.

Optional Laser Parameters (laser engraving):

Colour	Process	Power (%)	Speed (%)	ppi/Hz
Black	Engrave CO2	80	30	500

Passes	Air Assist	Z-Offset	Advanced
1	on	-	-

 Laser Cutting Parameters:

Colour	Process	Power (%)	Speed (%)	ppi/Hz
Red	Cut CO2	10	1.5	1000
Blue	Cut CO2	7	2	1000

Colour	Passes	Air Assist	Z-Offset	Advanced
Red	1	on	-	-
Blue	1	on	+3mm	-

Insert the eyelet before you close the lateral seam. Please ensure you follow the instructions provided with the eyelets.

Close the seam on the left and the right side of the cover. The scratching lines help you to use the correct position for the seam.

Now insert the rubber band, tie it together and your laptop bag is ready for use.