--------------------------
  1. Trotec Laser
  2. Resursi
  3. Laserski projekti
  4. Felt Quiver
felt quiver laser engraving

Felt Quiver

Step by step guide

Priprema

Required material
  • 4mm Polyesterfelt in any color
  • 3.5mm solid wood alder
  • wool in any color
  • sticky tape
Used Trotec Laser
  • Speedy 400
  • 80 watts
  • 2.0 inch lens
Tip

Vacuum table with honeycomb cutting tabletop or aluminum cutting grid table

felt-quiver-JC.zip

ZIP

Preuzmite odmah
felt-quiver-wood-JC.zip

ZIP

Preuzmite odmah
csm_felt-quiver_164181aa44.png

PDF

Preuzmite odmah

Detaljni vodič

Korak 1

Step 1: Design

Import the PDF file into Corel Draw and select your desired model and the design for either felt or wood (see the tabs below the working area in Corel Draw).

felt quiver laser engraving
Korak 2

Step 2: Laser parameters

Felt:

Engraving: Power: 33% - Speed: 50% - Frequency: 500 ppi - Air Assist: ON
- Advanced: Optimized Quality
Cutting: Power: 40% - Speed: 2% - Frequency: 1000 Hz - Air Assist: ON

Wood:

Engraving: Power: 60% - Speed: 50% - Frequency: 500 ppi - Air Assist: ON
Cutting: Power: 100% - Speed: 1.8% - Frequency: 1000 Hz - Air Assist: ON

textile quiver laser cutting
Korak 3

Step 3: Laser cut and engrave felt and wood

Before you begin with the cutting and engraving process, be sure to cover the cutting table around the felt with cardboard and sticky tape. This way the felt is properly fixed for laser cutting and engraving.
You can adjust the size of the felt in CorelDraw according to the length of the arrows you will be putting into your quiver. Our sample is best suited for very long arrows.
Send the file with the perfect size to your laser cutter. After you've taken the felt out of the laser, put your hardwood board inside. Now send the file for laser cutting and engraving the bottom part of the quiver to the laser.

laser engraving on wood and felt
Korak 4

Step 4: Sewing the pieces

Next you have to sew the round wooden plate and the felt along the holes together. Take the side with the pattern and sew it onto the wooden plate. Make sure the engraving will be on the outside. Sew the felt along the length and the remaining holes at the top together.

Our quiver is ready for your next archery training session. our quiver is ready for your next archery training session!

Serija Speedy
 Idealan laserski graver i sekač za personalizaciju.

Otkrijte laserske gravere i sekače

Da li imate pitanja o aplikacijama ili podešavanjima?
Drago nam je što možemo da vam pružimo detaljne savete, od Air Assist-a do z-pomaka.

Kontaktirajte nas
Ponosni član troGROUP Logo