User and Machine settings

This section explains how to change change some personal or machine settings.

Here you can change some personal or machine settings.

	Save your changes
	Choose how the units should be displayed
	Change your language
	Pdf layers import
	Choose your lid camera
	Choose a Home Position type
	Custom home position
	Custom home position
	Exhaust pre run time
	Exhaust post run time
	Check exhaust during process
	Air assist – Gas kit installed
	Choose a lens
	Print and cut
	Enable the vision camera

Vision camera calibration

Enable the Vision camera by clicking on the switch.
Click save to continue the process. (Settings must be saved before calibration is performed)
If your queue isn’t empty you will get a pop-up that your queue will get cleared.
Enter Parameter to cut through your calibration (eg. Power: 10%; Velocity: 1%)
Move the laserpointer to the spot where you want to cut the calibration circles.
Click on “Queue calibration job” to start the calibration.
Switch to the Produce Screen and start the job

Note: The camera detects the offset values and adds them to the settings.

Updated on 15. September 2021

Get personal support from our Ruby® experts.