Slate coaster

Use the following guide to make these individual coasters using standard slate plates. We also produced the appropriate storage for the coasters.

Preparation

Required material

6 slate coasters, approx. 10 x 10 cm
1 sheet of solid wood oak 600 x 300 mm

Machine used

Speedy 100 flexx
40 Watt
2" lens
Honeycomb cutting table for wood cutting

For this sample you only can use any laser machine from the S peedy laser engraver series.

DIY Slate Coaster

ZIP

Download now

ZIP

Download now

Slate Coaster

ZIP

Download now

ZIP

Download now

Step by step

Step 1

Step 1: Slate

Make your own design or import our template. Adapt the graphic if necessary to the size of the slate sheets.

Then send the job to the laser using the driver settings below.

Print settings:

Process mode	Resolution	Cut line
Standard	500 dpi	none

Halftone	Others
Color	-

Step 2

Step 2: Laser process slate

Determine and enter the material parameter settings. The parameters can vary depending on laser machine and available laser power.

Tip:

For faster production, engrave all coasters in one step. Since the individual pieces are not 100% identical, pay special attention to the precise positioning of the graphic.

Laser Parameters engraving

Color	Process	Power (%)	Speed (%)	ppi/Hz
black	Engrave CO₂	60	100	500

Passes	Air Assist	Z-Offset	Advanced
1	on	-	-

Step 3

Step 3: Storage

Make your own design or import our template. Adapt the graphic if necessary to the size of the slate sheets.

Send the job to the laser using the driver settings below.

Tip:

Before cutting, measure the thickness of the wooden sheet and adapt the kerf if necessary. Also make sure that the slate coasters fit into the storage.

Print settings:

Process mode	Resolution	Cut line
Standard	500 dpi	none

Halftone	Others
Color	Optimized geometries, inner geometries first

Step 4

Step 4: Laser process storage

Make the material parameter settings. The parameters can vary depending on laser machine and available laser power.

Laser Parameters cutting

Color	Process	Power (%)	Speed (%)	ppi/Hz
red	Cut CO₂	95	0.3	1000

Passes	Air Assist	Z-Offset	Advanced
1	on	-	-

Info:

We used the standard parameters in JobControl for solid wood oak.

Step 5

Step 5: Finishing

Connect the individual pieces of the storage box and put the laser engraved coasters into it.

Inspirations

You can use any design for the slate coasters. Laser engrave logos, images or other designs of your customers. In addition you can personalise the storage box for your customers with engravings.

Speedy series
The ideal laser engraver and cutter for personalisation.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.