Create a board game
with your laser

Start with determining the exact size that you would like you board game to be. In our example, we are using 50 x 50 cm of pre-cut acrylic for ours, but you can easily tailor this design to fit your own needs and simply send the file to the laser.

Tip:

To reduce the amount of post-processing needed as well as achieve the best engraving results, the board should be engraved starting with the bottom up to the top.

For each color that you are using, cut five circles out of the 0.8 mm acrylic, which will be used to outline each players area.

To achieve the best results, we suggest using the white acrylic-cutting-grid as well as leaving the protective film backing on the material while processing your cuts. Note: Acrylic can typically be purchased with protective adhesive backing to prevent material scratching while processing. 

Once the cuts are complete, ensure that your game board is clean and then simply position the circles appropriately.  

We filled some of the empty spaces on the game board with stickers to make it more fun.

For our board, we laser engraved TroLase Lights laminates and used the Kiss Cut parameters in JobControl to “cut-in” the material. With this technique, only the adhesive film is processed and the remaining material goes untouched. Once completed, the sticker is easily removed. 

Note: Similar to step one of this tutorial, it is important to laser engrave the stickers using the bottom to the top processing technique.

We worked with a Speedy 360 80 watts power and the parameters listed below. You can download the JobControl files and import them easily into your parameters database (see download area below). 

Game Board - TroLase 1,6 mm

Engraving: power: 80% - speed: 100% - frequency: 500 ppi - air assist: ON - Z-Offset: 1.5 mm
To achieve the best engraving results, we've activated the "high quality" function and set 1.5mm Z-Offset. 

Dots - Acrylic 0,8 mm

Cutting: power: 33% - speed: 1.2% - frequency: 1.000 Hz - air assist: ON

Player Figures - Acrylic 3,2 mm

Cutting: power: 45% - speed: 0.4% - frequency: 1.000 Hz - air assist: ON - 
Z-Offset: -0,6 mm
For a smoother engraving we also worked with 0.6mm Z-Offset here.

Decorative Stickers - TroLase Lights 0,1 mm - TroLase Lights 0,1 mm

Engraving: power: 35% - speed: 50% - frequency: 500 ppi - air assist: ON - Z-Offset: 2 mm
Cutting: power: 20% - speed: 2 % - frequency: 1.000 Hz - air assist: ON 
KissCut: power: 8% - speed: 2% - frequency: 1.000 Hz - air assist: ON
Here, we also suggest activating the "high quality" function. The laser process will take more time, but the perfect result is worth it.