--------------------------
Inspirations for wooden napkin rings

Napkin ring made with technical cutting for bending applications

The following step-by-step instructions demonstrate how to use the "kerf cutting" technique to make a wooden napkin ring.

Preparation

Required Material
Machine Used
  • Speedy 360, 120 Watt
  • 1.5" Lens
  • big and small nozzle
  • vacuum table with acrylic and honeycomb cutting tables

You can produce this design using any laser machine from the Trotec Laser Speedy series.

Tips

Consider using a 1.5" lens to produce the detailed cuts in the design.

napkin-ring.zip

ZIP

Download now

Step by step

Step 1

Step 1: Design

First, decide on a design. You can create your own design, or import our graphic and adapt it to your requrements. We determined parameters using our pre-tested cutting techniques for bending applications. Cehck out our tips & tricks on "Kerf Cut" to find more examples of how you can use this application.

Print Settings:

Process mode Resolution Cut line
Vector Job 1000dpi No
Halftone Others
Color Optimized Geometries, Inner Geometries first
lasercut wooden napkin ring
Step 2

Step 2: Laser processing the wood veneer

Start by placing the honeycomb cutting table in your Trotec laser, and then attach the small nozzle to the laser head. Next, place the walnut plate in your laser and cover the remaining working surface. The parameters may vary based on the laser machine you are using and available laser power.

Laser parameters:

Color Process Power (%) Speed (%) ppi/Hz
Red Cut CO2 100 1.2 1,000
Passes Air Assist Z-Offset Advanced
1 On 0mm -

For more information and assistance on choosing the right nozzle, access our laser tips on How to choose the right nozzle.

Print settings trolase foil
Step 3

Step 3: Send the graphic

Send the graphic for the TroLase Foil decoration to your Trotec Laser machine using the following print settings:

Process mode Resolution Cut line
Vector Job 1000dpi No
Halftone Others
- Optimized Geormetries, Inner Geometries First
laser cutting trolase foil
Step 4

Step 4: Laser process the TroLase Foil

Replace honeycomb cutting table with the acrylic grid cutting table, and then install the large nozzle. Insert the TroLase Foil into the laser and cover the rest of the working area.

Laserparameter:

Color Process Power (%) Speed (%) ppi/Hz
Red Cut CO2 20 1.0 1000
Passes Air Assist Z-Offset Advanced
1 On 0mm -

Tip:

Because TroLase Foil is very thin, it is important to closely monitor the vacuum to make sure a flat surface is maintained throughout the laser process.

Assembly wooden napkin ring
Step 5

Step 5: Cleaning and assembly

After processing is complete, use a damp cloth to clean the two pieces. It is also a good idea to clean the back of the wooden ring so that the napkin does not get dirty later.

Keep the wooden napkin ring flat and glue the TroLase Foil about half off. Make sure that the overhanging half does not stick to the napkin by scoring and removing half the adhesive foil on the back with a craft knife. To finish, form a ring around a cloth napkin and secure it with the circular connector.

Inspirations for wooden napkin rings

Inspiration

Experiment with different types of veneered wood or TroLase Foil colors to create different designs or to match an event theme.

You can use your Trotec laser and Trotec materials to create an entire table top or theme. See example in our DIYs.

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.

Contact us
Proud member of troGROUP Logo