Wooden garden decoration

Design a nice wooden garden decoration on your laser using the instructions and template below.

Preparation

Required material

Massive wood beam (we used a 750 x 150 x 150 mm beech beam)
Lantern
Candle

Machine used

Trotec Speedy 400 flexx
120 Watts with 2.85" flexx lens

Tips

We recommend a 2.5" lens if you are working with a CO₂ laser instead of a Speedy flexx.
Use an aluminum cutting grid table, a vacuum table or the standard engraving table

Wooden lantern

PDF

Download now

PDF

Download now

Step by step

Step 1

Step 1: Import/create design template

Import our design template into your graphics program and adapt it to the size of your wooden block.

TIP:

We made the engraving border of the graphic a little bit bigger than the actual size of the wood beam to make up for any size differences of the wood.

Step 2

Step 2: Laser process

Send the laser job to the machine.

LASER PARAMETERS

power 50%, speed 100%, 500 dpi, Air Assist on, z-offset 6 mm, HQ mode (advanced settings)

TIPS:

Select these two options in JobControl^® to get the best cutting results.

500 dpi
Black and white

Important: Laser parameters can vary depending on the machine and laser power you use.

TIPS:

To get the exact starting position, measure the middle of the block and move laser there. Then snap the middle of the job to the laser

Step 3

Step 3: Post-processing

The material requires no cleaning after engraving. Once you have finished engraving on all four sides, fix the candle holder on top of the wooden block and insert the candle. You can also put other items like a bowl on top of the wooden block. Your creativity is the only limit.

Speedy series
The ideal laser engraver and cutter for personalization.

Discover laser engravers and cutters

Questions about applications or settings?
We're happy to advise you from A for Air assist to Z for z-offset.