The first step is to either create your own design or use our template. With the integrated Photo mode of our JobControl Laser Software you are fully supported when engraving photos. Get more detailed information, as well as tips and tricks for photoengraving here:

Tips & Tricks photo engraving

Send your design to the laser using following settings:

Set the parameters as described below. The laser parameters may vary depending on your laser machine and the available laser power.

Remove the protective foil from the pink TroLase material and put it into your Trotec laser machine. Run the laser engraving (black) and the laser cutting jobs (red and blue).

To make your menu card stand out we combined two different materials. Send the second graphic, the rhombic pattern, to your laser machine by using the following parameters:

Tip:

• We used the parameter JobControl® standard optimised for quality.

Put your TroLase Thin material in your Trotec laser machine. Remove the protective foil, run the engraving job from bottom to top, and laser cut the job.

Clean the surface and the edges of the TroLase-materials using a damp cloth. Take the rhombic pattern and apply it to the photo engraved cover. To finish add your content to the menu card and clip it with the binding screw. And voilà - your menu card is complete.