Engraved leather phone case

Style up your mobile phone with this exclusive phone case made from leather. Personalize the pouch with your initials for an individual touch. Check out our instructions and templates below to engrave your own phone pocket.

Preparation

Required material

11 x 6 inch piece of microfiber e.g. Alcantara®

Used Trotec Laser

Speedy 300
80 watts
2 inch lens

Leather Phone Case

ZIP

Download now

ZIP

Download now

csm_Phone-Case-Laser-Template_b0916ba1eb.png

PDF

Download now

PDF

Download now

Step by step

Step 1

Step 1: Preparing the cutting file

Download the template file for the phone case. Open it in your preferred graphics software and edit the initials to those of the person the phone pocket is for.

Step 2

Step 2: Laser cutting the leather

Send the graphic file to the laser software with the parameters recommended below. Please note that the parameters may vary depending on the machine used and the laser power available.

Laser Settings

Engraving parameters (black graphic)
Power: 40 %, Speed: 80 %, Resolution: 500 ppi, air assist ON

Cutting parameters (red lines)
Power: 40 %, Speed: 4 %, Frequency: 1000 Hz, air assist ON

Step 3

Step 3: Assembling the parts

To finalize your engraved phone case you need to fold the two leather pieces and stitch them together along the dotted line which has been perforated by the laser. Do the same for the key chain.