Laser cut and engrave a
multi-layer sign

Open the file "Multi-layer-sign" in your graphics software, then send it to the laser. Settings for speed and laser power may vary depending on the machine used.

Black (engraving)

Power: 60 %, Speed: 100 %, Resolution: 500 dpi, air assist on, z-Offset: +1mm

Tip:

Use reverse engraving to protect your materials from dust and keep them clean.

Red (cutting)

• 3 mm Acrylics
  Power: 40 %, Speed 0,2 %, Frequency 20.000 Hz, air assist on
• 6 mm Acrylics
  Vector marking: Power: 10 %, Speed 1 %, Frequency 2000 Hz, air assist on
  Cutting: Power: 95 %, Speed 0,2 %, Frequency 20.000 Hz, Z-offset -2 mm, air assist on
• 10 mm Acrylics
  Cutting: Power: 95 %, Speed 0,1 %, Frequency 20.000 Hz, Z-offset -3 mm, air assist on

• Use the 2 inch lens for engraving the laminate and for cutting 3 mm acrylics
• For cutting acrylics of 6 or 10 mm use the 2.5 inch lens and keep in mind that a good exhaust is very important for perfect cutting results when cutting acrylics.
• Proper preparation is the secret: Prepare the layers with double-sided adhesive tape, then the assembling only takes some minutes.
• Help yourself: Engraving the baseplate and the laminate helps for the correct positioning.
• Mounting a top layer on the 10 mm acrylics creates a visual multidimensional effect.
• Be creative! Post your sign ideas on our facebook - Page!